3.5mm Connector
(The fresh new pinout with the SparkFun connector is different as compared to TRRS connector that i used in the picture near the top of this informative article. Some of the pieces inside tutorial will be in additional urban centers to the board than what is found here.)
- Sleeve is actually floor.
- Ring2 are songs out (TX)
- Ring1 was PTT
- Idea was songs from inside the (RX)
PTT Circuitry
- Emitter within the good:21
- Feet into the an effective:twenty two
- Enthusiast when you look at the good:23
Work at a cable tv out-of age:23 (Collector) on the bad rail (Ground). Connect one to end of the the brand new 1KOhm resister to the age:twenty-two (Base) plus the almost every other toward grams:twenty two. Run a wire away from j:twenty two so you’re able to j:step three (Arduino D10) . Then work on a wire from e:21 to help you e:twenty eight (step 3.5mm Ring step one).
PTT (Alternate)
If for example the broadcast does not play with a new PTT signal, you will need one even more part. You may need 2.2KOhm resistor. Unlike a cable tv away from age:21 so you’re able to age:twenty-eight, make an effort to connect the two.2KOhm resistor off d:21 so you can d:17, and then manage the fresh cable out of e:17 so you can age:30. Devamını Oku
Son yorumlar